Receiving Hoppers
Receiving Hoppers
This system is most commonly used for feeding your destemmer-crusher with 1/2 ton picking bins. The design and function provides for a very consistent and metered feed. The legs are adjustable for feeding the discharge directly to press. This receiving hopper can also be utilized for feeding red pomace back to press.
Height adjustments are made easily with your forklift for use in any scenario.
Whole Cluster Fruit to Press
Fermented Red Must to Press
Feed Destemmer-Crusher
Feed Sorting Table
Designed for dumping half-ton bins into on the fly, the Carlsen 6-Foot Horizontal Receiving Hopper is the key to best results from your destemmer. By supplying the destemmer with a specific flow rate of grapes, the operator can then dial in the perfect speed at the destemmer. In a hand- picked fruit scenario, a receiving hopper could minimize the need for sorting grapes. And it will save labor and increase the quality of the destemmed fruit that is accepted during sorting.
Is it GENTLE on grapes?
A horizontal, tight-fitting, flight-edged, polished interior, oversized, contiguous-welded, seamless shaft auger is not harming the fruit. There is no pinch zone between the hopper floor and the screw. There is negligible, if any increase in solids using this hopper. The energy used to move the fruit is not wasted, as the bunches slide easily on the polished stainless interior of the hopper. This design is gentler than hand-raking fruit out of a bin, into the destemmer. It is also much more efficient, and that saves labor.
Applications
1 to 25 tons per hour
Feeding Fruit to the Destemmer
Feeding Fruit to the Press
Feeding Red Pomace to the Press
Standard Features
Adjustable Legs
Variable Speed
Stainless Steel Casters
Hinged Lid
12" Stainless Steel Screw
Two-Year Warranty
Call for Pricing
Construction
12 gauge stainless steel body
Adjustable legs for discharge range of 63" to 106"
3" stainless steel tube frame
Optional leveling feet
Stainless steel casters with brakes
Screw Conveyor
12" diameter stainless steel conveyor screw
Seal-welded on both sides of flight
UHMW flight edging
Motor and Gearbox
2 hp 1750 rpm TEFC motor
30 rpm gearbox
Controls
Variable frequency drive
Waterproof enclosure
Stop/Start and speed control are panel mounted
Forward/Reverse Switch
50’ of power cord (the electrical plug is to be supplied by the customer)
Pigtail on the electrical panel included for remote operations